Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2016.11
RM3160E _54 Brake _019692 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0106374 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1428  Motor Circuit Malfunction  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
C1428 Motor Circuit Malfunction With the ABS motor relay off and the ABS motor fail-safe relay off, an open in the pump motor circuit continues for 2 seconds or more. Brake actuator assembly (motor circuit)

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

When replacing the pump motor (brake actuator assembly), perform zero point calibration and store system information.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (GND2 TERMINAL)
a.
C364228C18
1.479,0.104 1.906,0.375 0.427,0.271 0.479,1.792 0.688,0.938 true 1.573,0.156 2.031,0.354 0.458,0.198 10 false A86 0.344,1.844 0.802,2.042 0.458,0.198 10 false GND2 0.24,0.208 0.698,0.406 0.458,0.198 10 false *a
*a Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly))


Make sure that there is no looseness at the locking part and the connecting part of the connectors.


b.

Disconnect the A86 skid control ECU (brake actuator assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A86-1 (GND2) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (GND2 CIRCUIT)