The ECM communicates with the generator assembly via LIN communication. If a LIN communication error is detected, the ECM stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Memory | Note |
|---|---|---|---|---|---|---|
| P161A87 | Lost Communication with Alternator Missing Message | Generator assembly or ECM communication stops for approximately 17 minutes or more with the ignition switch ON.
(1 trip detection logic) |
·
Wire harness or connector ·
Generator assembly ·
ECM |
Charge warning is not displayed | DTC stored | SAE Code: P161A |
Check the charging system.
Click herePower Source / Network>2GR-FKS BATTERY / CHARGING>CHARGING SYSTEM>ON-VEHICLE INSPECTION
| Result |
|---|
| OK |
| NG |
OK
NG
Disconnect the C1 ECM connector.
Disconnect the C81 generator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C1-135 (LIN) - C81-2 (LIN) | Always | Below 1 Ω |
| C1-135 (LIN) or C81-2 (LIN) - body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG