11401M
1.INSTALL VVT SENSOR (for Exhaust Side of Bank 2)
Apply a light coat of engine oil to the O-ring of the VVT sensor.
If reusing the VVT sensor, be sure to inspect the O-ring.
Clean the bolt and bolt hole.
| *a | Adhesive |
Apply adhesive to 2 or 3 threads at the end of the bolt.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the VVT sensor to the cylinder head cover sub-assembly LH with the bolt.
If the VVT sensor has been struck or dropped, replace it.
Make sure that the O-ring is not cracked or moved out of place when installing the VVT sensor.
Connect the VVT sensor connector.
11401M
2.INSTALL VVT SENSOR (for Intake Side of Bank 2)
Apply a light coat of engine oil to the O-ring of the VVT sensor.
If reusing the VVT sensor, be sure to inspect the O-ring.
Clean the bolt and bolt hole.
| *a | Adhesive |
Apply adhesive to 2 or 3 threads at the end of the bolt.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the VVT sensor to the cylinder head cover sub-assembly LH with the bolt.
If the VVT sensor has been struck or dropped, replace it.
Make sure that the O-ring is not cracked or moved out of place when installing the VVT sensor.
Connect the VVT sensor connector.
11401M
3.INSTALL VVT SENSOR (for Exhaust Side of Bank 1)
Apply a light coat of engine oil to the O-ring of the VVT sensor.
If reusing the VVT sensor, be sure to inspect the O-ring.
Clean the bolt and bolt hole.
| *a | Adhesive |
Apply adhesive to 2 or 3 threads at the end of the bolt.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the VVT sensor to the cylinder head cover sub-assembly with the bolt.
If the VVT sensor has been struck or dropped, replace it.
Make sure that the O-ring is not cracked or moved out of place when installing the VVT sensor.
Connect the VVT sensor connector.
11401Q
4.INSTALL VVT SENSOR (for Intake Side of Bank 1)
Apply a light coat of engine oil to the O-ring of the VVT sensor.
If reusing the VVT sensor, be sure to inspect the O-ring.
Clean the bolt and bolt hole.
| *a | Adhesive |
Apply adhesive to 2 or 3 threads at the end of the bolt.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the VVT sensor to the cylinder head cover sub-assembly with the bolt.
If the VVT sensor has been struck or dropped, replace it.
Make sure that the O-ring is not cracked or moved out of place when installing the VVT sensor.
Connect the VVT sensor connector.
17190
5.INSTALL INTAKE AIR SURGE TANK ASSEMBLY
6.INSPECT FOR ENGINE OIL LEAK