Home › Drivetrain › UA80F (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH › from 2016.11
RM3160E _52 Drivetrain _060165 UA80F AUTOMATIC TRANSMISSION / TRANSAXLE _0303755 PARK / NEUTRAL POSITION SWITCH A

UA80F AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Move the shift lever to N.


b.

Temporarily install the park/neutral position switch assembly to the automatic transaxle case sub-assembly with the 2 bolts.

NOTICE:

Before installing the park/neutral position switch assembly, remove any dirt or rust on the manual valve lever shaft sub-assembly. Be sure to install the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be installed correctly.



c.

Temporarily install the transmission control shaft lever to the park/neutral position switch assembly.


d.
C361030C01
1.427,1.802 1.646,2 0.219,0.198 10 true *b 0.229,1.469 0.448,1.667 0.219,0.198 10 true *a
*a P Position
*b N Position


Turn the transmission control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.


e.

Remove the transmission control shaft lever from the park/neutral position switch assembly.


f.
C361029C01
2.688,1.031 1.823,0.823 true 1.625,0.688 0.76,0.833 true 2.75,0.969 2.969,1.188 0.219,0.219 10 true *a 0.573,0.75 0.802,0.948 0.229,0.198 10 true *b
*a Neutral Basic Line
*b Protrusion


Align the protrusion with the neutral basic line.


g.

Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


h.

Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


i.

Connect the park/neutral position switch assembly connector.


Hide 33820B 2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Connect the transmission control cable assembly to the transmission control shaft lever and install the clip.

NOTICE:

Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in neutral.



Hide 17701 3.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

a.

Engage the guide to the grommet of the air cleaner support bracket to temporarily install the air cleaner case sub-assembly.


b.

Install the air cleaner case sub-assembly with the 2 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 17801 4.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

a.

Install the air cleaner filter element sub-assembly to the air cleaner case sub-assembly.


Hide 17705 5.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE