33550
1.INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY
Check that the park/neutral position switch assembly and the shift lever are in neutral.
Temporarily install the transmission floor shift assembly to the shift lever support with the 4 nuts.
Install the 4 nuts in the order shown in the illustration.
| *a | Lock Nut |
| *b | Push in |
| *c | Stopper |
Turn the lock nut of the transmission control cable assembly counterclockwise. While holding the lock nut, push in the stopper.
| *a | Stopper |
Install the transmission control cable assembly to the transmission floor shift assembly.
After installation, check that the outer part of the stopper is protruding beyond portion A-A as shown in the illustration.
Confirm that the shift lever is in N, and then install the transmission control cable assembly to the transmission floor shift assembly.
Securely install the end of the transmission control cable assembly to the transmission floor shift assembly.
Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.
Connect the shift lock control ECU connector.
Connect the transmission control switch connector.
58996A
2.INSTALL NO. 2 CONSOLE BOX MOUNTING BRACKET
Install the No. 2 console box mounting bracket to the transmission floor shift assembly with the 2 screws.
Engage the clamp to the No. 2 console box mounting bracket.
58816B
3.INSTALL CONSOLE BOX INSERT
58817A
4.INSTALL FRONT NO. 2 CONSOLE BOX INSERT
55446E
5.INSTALL NO. 2 SWITCH HOLE BASE
35978
6.INSTALL SHIFT POSITION INDICATOR
Engage the claw and 2 guides to install the shift position indicator to the shifting hole bezel.
58843
7.INSTALL SHIFTING HOLE BEZEL
Install the shifting hole bezel to the upper console panel sub-assembly with the 5 screws.
Connect the shift position indicator connector.
8.INSTALL CONSOLE BOX ASSEMBLY
33554
9.INSTALL SHIFT LEVER CAP
Engage the 2 claws to install the shift lever cap to the shift position indicator.
10.INSPECT SHIFT LEVER POSITION