86101J
1.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (for Normal Roof)
86101J
2.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (for Sliding Roof)
86300B
3.REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY
863C0
4.REMOVE DIGITAL AUDIO BROADCASTING ANTENNA ASSEMBLY (w/ DAB Function)
5.REMOVE REAR WASHER HOSE ASSEMBLY (for Normal Roof)
w/ Adhesive Tape:
Remove the adhesive tape from the roof headlining assembly.
| *A | w/ Adhesive Tape | - | - |
Remove the rear washer hose assembly from the roof headlining assembly.
6.REMOVE REAR WASHER HOSE ASSEMBLY (for Sliding Roof)
w/ Adhesive Tape:
Remove the adhesive tape from the roof headlining assembly.
| *A | w/ Adhesive Tape | - | - |
Disengage each clamp and remove the rear washer hose assembly from the roof headlining assembly.
7.REMOVE AIR DUCT SEAL
Use the same procedure for all air duct seals.
Remove the air duct seal.
81390C
8.REMOVE SPOT LIGHT ASSEMBLY LH
Click hereVehicle Interior>LIGHTING (INT)>ROOM LIGHT>REMOVAL
Use the same procedure for the front side and rear side.
81360K
9.REMOVE SPOT LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
63398
10.REMOVE ROOF HEADLINING SUPPORT PLATE (for Normal Roof)
Remove the 2 roof headlining support plates.
63398
11.REMOVE ROOF HEADLINING SUPPORT PLATE (for Sliding Roof)
Remove the 2 roof headlining support plates.
82171
12.REMOVE NO. 1 ROOF WIRE (for Normal Roof)
Remove the adhesive tape from the roof headlining assembly.
| *A | w/o Pre-collision System | *B | w/ Pre-collision System |
| *C | for LHD with Rain Sensor | *D | w/ EC Mirror |
| *E | for RHD with Rain Sensor | - | - |
|
Adhesive Tape | - | - |
Turn the 2 visor connectors counterclockwise approximately 45° and remove them from the roof headlining assembly.
| *A | w/o Pre-collision System | *B | w/ Pre-collision System |
| *C | for LHD with Rain Sensor | *D | w/ EC Mirror |
| *E | for RHD with Rain Sensor | - | - |
| *a | 45° | - | - |
Disengage each clamp and remove the No. 1 roof wire from the roof headlining assembly.
82171
13.REMOVE NO. 1 ROOF WIRE (for Sliding Roof)
Remove the adhesive tape from the roof headlining assembly.
| *A | w/o Pre-collision System | *B | w/ Pre-collision System |
| *C | for LHD with Rain Sensor | *D | for RHD with Rain Sensor |
| *E | w/ Rear Seat Entertainment System | - | - |
|
Adhesive Tape | - | - |
Turn the 2 visor connectors counterclockwise approximately 45° and remove them from the roof headlining assembly.
| *A | w/o Pre-collision System | *B | w/ Pre-collision System |
| *C | for LHD with Rain Sensor | *D | for RHD with Rain Sensor |
| *a | 45° | - | - |
Disengage each clamp and remove the No. 1 roof wire from the roof headlining assembly.