Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
RM37A0E _59 Vehicle Exterior _086888 LIGHTING (EXT) _0415934 LIGHTING SYSTEM J

LIGHTING (EXT)  LIGHTING SYSTEM  Front Fog Light Circuit  


DESCRIPTION

The main body ECU (multiplex network body ECU) controls the front fog lights.

WIRING DIAGRAM

E435631E01
4.667,1.333 5.719,1.875 1.052,0.542 10 false Instrument Panel Junction Block Assembly 5.458,4.323 7.083,4.76 1.625,0.438 10 false Main Body ECU (Multiplex Network Body ECU) 2.198,3.094 3.771,3.365 1.573,0.271 10 false Fog Light Assembly LH 2.188,4.448 3.875,4.74 1.688,0.292 10 false Fog Light Assembly RH 3.563,1.313 4.333,1.594 0.771,0.281 10 false FOG FR 2.375,0.833 3.146,1.115 0.771,0.281 10 false FOG FR 6.01,0.563 6.5,0.771 0.49,0.208 10 false FFGO 4.656,1.156 5.146,1.365 0.49,0.208 10 false 4C 4.458,0.573 4.656,0.75 0.198,0.177 10 false 25 4.104,0.896 4.302,1.073 0.198,0.177 10 false 3 4.115,0.583 4.313,0.76 0.198,0.177 10 false 1 3.438,0.583 3.635,0.76 0.198,0.177 10 false 2 3.438,0.896 3.646,1.083 0.208,0.188 10 false 5 0.448,0.958 1.573,1.177 1.125,0.219 10 false from ALT Fuse*2 3.552,2.198 3.75,2.375 0.198,0.177 10 false 2 3.552,3.563 3.75,3.74 0.198,0.177 10 false 2 2.052,2.198 2.25,2.385 0.198,0.188 10 false 1 2.073,3.573 2.271,3.76 0.198,0.188 10 false 1 2.198,2.927 2.531,3.115 0.333,0.188 10 false A59 2.188,4.281 2.521,4.469 0.333,0.188 10 false A58 2.563,2.5 3.406,2.677 0.844,0.177 10 false Fog Light 2.573,3.854 3.417,4.031 0.844,0.177 10 false Fog Light 3.323,2.198 3.521,2.375 0.198,0.177 10 false B 3.323,3.563 3.521,3.74 0.198,0.177 10 false B 2.271,2.208 2.469,2.385 0.198,0.177 10 false E 2.271,3.573 2.469,3.75 0.198,0.177 10 false E 5.458,4.146 5.948,4.354 0.49,0.208 10 false MB 5.802,0.563 6,0.74 0.198,0.177 10 false 7 0.271,0.656 1.531,0.875 1.26,0.219 10 false from DC/DC Fuse*1 0.458,4.938 2.292,5.229 1.833,0.292 10 false *1: for HV Model 0.458,5.344 2.302,5.573 1.844,0.229 10 false *2: for Gasoline Model

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

The vehicle battery supplies power to the main body ECU (multiplex network body ECU) via the door control battery. Therefore, before performing this troubleshooting procedure, make sure to perform an on-vehicle inspection to confirm that the main body ECU (multiplex network body ECU) power source circuit is normal.*

·

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.

*: w/ Door Control Battery




PROCEDURE

1.CHECK OPERATION (TAILLIGHTS)
a.

Check the operation of the taillights.

OK:

Taillights operate normally.



Result:
Proceed to
OK
NG



OK

2.PERFORM ACTIVE TEST USING GTS

NG

2.PERFORM ACTIVE TEST USING GTS
a.

Perform the Active Test according to the display on the GTS.

Body Electrical > Main Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Front Fog Light Relay Front fog lights OFF or ON -
Body Electrical > Main Body > Active Test
Tester Display
Front Fog Light Relay
50004 123 16
OK:

Front fog light relay operates. (Front fog lights come on.)



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

3.CHECK HARNESS AND CONNECTOR (POWER SOURCE - FOG FR RELAY)
3.CHECK HARNESS AND CONNECTOR (POWER SOURCE - FOG FR RELAY)
a.

Remove the FOG FR relay.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (FOG FR relay) - Body ground Ignition switch off*1
Always*2
11 to 14 V
5 (FOG FR relay) - Body ground Ignition switch off*1
Always*2
11 to 14 V


*1: for HV Model

*2: for Gasoline Model



Result:
Proceed to
OK
NG



OK

4.INSPECT FOG FR RELAY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT FOG FR RELAY

OK

5.CHECK HARNESS AND CONNECTOR (FOG FR RELAY - FOG LIGHT ASSEMBLY)

NG

REPLACE FOG FR RELAY

5.CHECK HARNESS AND CONNECTOR (FOG FR RELAY - FOG LIGHT ASSEMBLY)
a.

Disconnect the A59 fog light assembly LH connector.


b.

Disconnect the A58 fog light assembly RH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 (FOG FR relay) - A59-2 (B) Always Below 1 Ω
3 (FOG FR relay) - A58-2 (B) Always Below 1 Ω
3 (FOG FR relay) or A59-2 (B) - Body ground Always 10 kΩ or higher
3 (FOG FR relay) or A58-2 (B) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

6.CHECK HARNESS AND CONNECTOR (FOG FR RELAY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK HARNESS AND CONNECTOR (FOG FR RELAY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)
a.

Disconnect the 4C instrument panel junction block assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (FOG FR relay) - 4C-25 Always Below 1 Ω
1 (FOG FR relay) or 4C-25 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

7.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
E367360C33
1.74,0.583 2.115,0.833 0.375,0.25 4.875,0.938 5.25,1.188 0.375,0.25 4.563,2.052 4.146,1.531 false 0.479,0.438 0.792,0.635 0.313,0.198 10 false *a 1.844,0.625 2.156,0.823 0.313,0.198 10 false 4C 4.948,0.979 5.26,1.177 0.313,0.198 10 false MB 4.427,2.073 4.958,2.302 0.531,0.229 10 false FFGO
*a Component without harness connected
(Instrument Panel Junction Block Assembly)
- -


a.

Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4C-25 - MB-7 (FFGO) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY