Home › Engine / Hybrid System › 2GR-FKS (INTAKE / EXHAUST) › EXHAUST PIPE
RM37A0E _51 Engine / Hybrid System _086854 2GR-FKS INTAKE / EXHAUST _0416462 EXHAUST PIPE A

2GR-FKS INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly, center exhaust pipe assembly (TWC: Rear Catalyst) and tail exhaust pipe assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of heated oxygen sensor

·

Gas leak from exhaust system is repaired


Perform Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
A344784

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


PROCEDURE

Hide 17430 1.REMOVE TAIL EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A454271

Remove the 2 bolts and 2 compression springs to disconnect the tail exhaust pipe assembly from the center exhaust pipe assembly (TWC: Rear Catalyst).


b.
A454272

Remove the tail exhaust pipe assembly from the 4 exhaust pipe supports.


c.

Remove the gasket from the center exhaust pipe assembly (TWC: Rear Catalyst).


Hide 17420 2.REMOVE CENTER EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A454273

Remove the 2 bolts and 2 compression springs to disconnect the center exhaust pipe assembly (TWC: Rear Catalyst) from the front exhaust pipe assembly.


b.

Remove the center exhaust pipe assembly (TWC: Rear Catalyst) from the 2 exhaust pipe supports.


c.

Remove the gasket from the front exhaust pipe assembly.


Hide 17410 3.REMOVE FRONT EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A455883

Disengage the 2 wire harness clamps.


b.

Disconnect the heated oxygen sensor (for Bank 1) connector.


c.
A454258

Disengage the 2 wire harness clamps.


d.

Disconnect the heated oxygen sensor (for Bank 2) connector.


e.
A454274

Remove the 4 nuts and front exhaust pipe assembly from the exhaust manifold assembly RH (TWC: Front Catalyst) and exhaust manifold assembly LH (TWC: Front Catalyst).


f.

Remove the 2 gaskets from the front exhaust pipe assembly.


Hide 89465A 4.REMOVE HEATED OXYGEN SENSOR (for Bank 1)

Hide 89465 5.REMOVE HEATED OXYGEN SENSOR (for Bank 2)