The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below.
17410
1.REMOVE FRONT EXHAUST PIPE ASSEMBLY
89465A
2.REMOVE HEATED OXYGEN SENSOR (for Bank 1)
Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.
If the heated oxygen sensor has been struck or dropped, replace it.
89465
3.REMOVE HEATED OXYGEN SENSOR (for Bank 2)
Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.
If the heated oxygen sensor has been struck or dropped, replace it.