Home › Vehicle Interior › SEAT › FRONT SEATBACK HEATER (for Manual Seat) › 2020.02–2020.11
RM37A0E _58 Vehicle Interior _086894 SEAT _0416496 FRONT SEATBACK HEATER(for Manual Seat) A

SEAT  FRONT SEATBACK HEATER(for Manual Seat)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seatback heater assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

CAUTION:
B543257

Wear protective gloves. Sharp areas on the parts may injure your hands.


NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.


Hide 71073S 3.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 72551B 4.REMOVE RECLINING HINGE COVER

Hide 72525A 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE

Hide 71811D 6.REMOVE FRONT SEAT CUSHION SHIELD

Hide 71861 7.REMOVE FRONT SEAT INNER CUSHION SHIELD

Hide 8.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 71930A 9.REMOVE FRONT SEAT HEADREST SUPPORT ASSEMBLY

Hide 10.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Hide 71073S 11.REMOVE SEPARATE TYPE FRONT SEATBACK COVER

Hide 87510M 12.REMOVE FRONT SEATBACK HEATER ASSEMBLY

a.
B481878

Remove the 24 tag pins and front seatback heater assembly from the separate type front seatback cover.