Home › Engine / Hybrid System › A25A-FXS, A25B-FXS (EMISSION CONTROL) › CANISTER
RM37A0E _51 Engine / Hybrid System _086908 A25A-FXS EMISSION CONTROL _0416582 CANISTER A

A25A-FXS EMISSION CONTROL  CANISTER  REMOVAL  


PROCEDURE

Hide 58166A 1.REMOVE FRONT FLOOR COVER LH

Hide 77740 2.REMOVE CANISTER (CHARCOAL CANISTER ASSEMBLY)

a.

Disconnect the fuel tank evaporation vent tube sub-assembly from the canister (charcoal canister assembly).

A457799C01
2.469,2.323 2.719,2.531 2.719,2.531 2.885,2.531 false 2.594,1.958 2.74,1.729 2.74,1.729 2.906,1.729 false 2.208,1.948 2.115,1.719 2.115,1.719 1.906,1.719 false 5.813,1.104 5.719,0.875 5.719,0.875 5.51,0.875 false 5.302,1.646 5.302,2.104 5.302,2.104 4.896,2.104 true 5.156,2.094 5.156,1.646 true 6.385,1.333 6.25,0.573 6.25,0.573 6.042,0.573 false 2.896,2.438 3.26,2.688 0.365,0.25 10 false *a 2.979,1.646 3.375,1.958 0.396,0.313 10 false *b 5.344,0.792 5.74,1.188 0.396,0.396 10 false *c 4.698,2.021 5.052,2.281 0.354,0.26 10 false *d 5.844,0.479 6.177,0.802 0.333,0.323 10 false *e 1.729,1.646 2.125,1.958 0.396,0.313 10 false *b
*a Retainer *b Tab
*c Tube Connector *d O-ring
*e Pipe (Canister (Charcoal Canister Assembly)) - -
V100135

Pinch
V100136

Pull


NOTICE:
·

Remove any dirt or foreign matter on the tube connector before performing this work.

·

Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the tube connector has O-rings that seal the pipe (canister (charcoal canister assembly)).

·

Perform this work by hand. Do not use any tools.

·

Do not forcibly bend, twist or turn the fuel tank evaporation vent tube sub-assembly.

·

Protect the disconnected parts by covering them with plastic bags after disconnecting the fuel tank evaporation vent tube sub-assembly.

·

If the tube connector and pipe (canister (charcoal canister assembly)) are stuck, push and pull to release them.



HINT:

Do not remove the retainer.


i.

Pinch the tabs of the retainer to detach the lock claws and pull it down.


ii.

Pull off the fuel tank evaporation vent tube sub-assembly.



b.
A457800

Slide the clip and disconnect the fuel emission hose from the canister (charcoal canister assembly).


c.
A457801

Slide the clip and disconnect the No. 7 fuel tank breather tube from the canister (charcoal canister assembly).


d.
A457802

Remove the 2 bolts.


e.
A457803

Remove the canister (charcoal canister assembly) from vehicle body as shown in the illustration.