Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT ASSEMBLY
RM37A0E _59 Vehicle Exterior _086888 LIGHTING (EXT) _0416592 LICENSE PLATE LIGHT ASSEMBLY A

LIGHTING (EXT)  LICENSE PLATE LIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 67848E 1.REMOVE BACK DOOR SERVICE HOLE COVER LH

Hide 67847 2.REMOVE BACK DOOR SERVICE HOLE COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 64780A 3.REMOVE BACK DOOR TRIM PANEL ASSEMBLY

Hide 76832A 4.REMOVE BACK DOOR FINISH PANEL COVER

Hide 81270 5.REMOVE LICENSE PLATE LIGHT ASSEMBLY

NOTICE:

If the license plate light assembly has been removed, replace the license plate light packing with a new one.


a.
E430199

Disconnect the connector.


b.
E430200C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 claws to remove the license plate light assembly as shown in the illustration.


Hide 81274B 6.REMOVE LICENSE PLATE LIGHT PACKING

a.
E274784

Remove the license plate light packing.

NOTICE:

Do not reuse the removed license plate light packing. Be sure to install a new license plate light packing to prevent water ingress.



Hide 81270B 7.REMOVE LICENSE PLATE LIGHT BULB

a.
E274785C04
0.167,1.354 0.333,1.771 true 0.99,0.635 0.906,1.052 true 1.115,1.354 1.031,1.75 true 2.552,0.24 2.469,0.656 true 3.177,1.208 3.094,1.625 true 0.073,1.156 0.385,1.354 0.313,0.198 10 false *c 0.948,1.74 1.26,1.938 0.313,0.198 10 false *a 2.49,0.042 2.802,0.24 0.313,0.198 10 false *b 0.927,0.438 1.24,0.635 0.313,0.198 10 false *b 3.115,1.031 3.427,1.229 0.313,0.198 10 false *c
*a Protective Tape
*b Insert into the hole
*c License Plate Light Lens Hole


Insert a screwdriver wrapped with protective tape into the license plate light lens hole, tilt it as shown in the illustration and disengage the 2 claws to remove the license plate light lens.


b.

Remove the license plate light bulb.