Home › General › MAINTENANCE › REAR TURN SIGNAL LIGHT BULB
RM37A0E _V1 General _086848 MAINTENANCE _0416702 REAR TURN SIGNAL LIGHT BULB A

MAINTENANCE  REAR TURN SIGNAL LIGHT BULB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 81498 1.REMOVE REAR COMBINATION LIGHT COVER

Hide 2.SEPARATE REAR COMBINATION LIGHT SUB-ASSEMBLY

a.
E430175C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear combination light sub-assembly as shown in the illustration.


b.
E430176

Remove the 2 screws.


c.
E430177C01
1.417,1.104 1.01,1.438 true 0.99,0.625 0.698,0.927 true 1.823,1.708 1,2.083 1,2.083 1.521,1.76 true 0.802,1.469 1.115,1.625 0.313,0.156 10 true *a 0.552,0.969 0.865,1.125 0.313,0.156 10 true *b 0.667,2 0.979,2.156 0.313,0.156 10 true *b
*a Pin
*b Guide
V113147

Separate in this Direction


Pull the rear combination light sub-assembly toward the rear of the vehicle as shown in the illustration to disengage the pin and 3 guides and separate the rear combination light sub-assembly.

NOTICE:

To prevent the rear combination light sub-assembly from falling when disengaging the pin and 3 guides, make sure to hold the rear combination light sub-assembly.



Hide 81550L 3.REMOVE REAR TURN SIGNAL LIGHT BULB

a.
E430139C01
0,0 0,0 false
V113147

Disconnect in this Direction


Turn the rear turn signal light socket with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.


b.

Remove the rear turn signal light bulb from the rear turn signal light socket.