Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM37A0E _58 Vehicle Interior _086889 METER / GAUGE / DISPLAY _0416706 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Operating Light Control Rheostat does not Change Light Brightness  


DESCRIPTION

The trip switch is connected to the combination meter assembly via direct line. When the light control rheostat up switch or light control rheostat down switch is operated, the brightness of the meter illumination changes.

WIRING DIAGRAM

E369057E07
1.438,3.031 2.146,3.208 0.708,0.177 10 false Trip Switch 1.438,2.875 1.823,3.052 0.385,0.177 10 false H23 1.031,1.75 2.406,2.115 1.375,0.365 10 false Light Control Rheostat Down Switch 1.042,0.813 2.417,1.177 1.375,0.365 10 false Light Control Rheostat Up Switch 4.792,3.333 6.646,3.563 1.854,0.229 10 false Combination Meter Assembly 4.792,3.177 5.094,3.375 0.302,0.198 10 false H22 4.948,2.375 5.302,2.563 0.354,0.188 10 false SW3 4.927,0.521 5.177,0.719 0.25,0.198 10 false TR 2.521,0.51 2.771,0.708 0.25,0.198 10 false RV 2.583,2.385 2.771,2.604 0.188,0.219 10 false E 2.833,2.385 3.021,2.604 0.188,0.219 10 false 1 4.719,2.375 4.906,2.594 0.188,0.219 10 false 5 4.729,0.521 4.917,0.74 0.188,0.219 10 false 2 2.844,0.51 3.031,0.729 0.188,0.219 10 false 4 6,0.198 6.354,0.396 0.354,0.198 10 false 5 V

CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.


HINT:

Even when the light control rheostat switch is not operated, the brightness of the meter illumination is dimmed automatically when the taillights illuminate.


PROCEDURE

1.READ VALUE USING GTS
a.

Read the Data List according to the display on the GTS.

Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Light Control Switch (UP) Light control rheostat up switch OFF or ON OFF: Switch released
ON: Switch pushed
When the switch is built into the combination meter assembly or is connected via direct line, the input value is displayed.
Light Control Switch (DOWN) Light control rheostat down switch OFF or ON OFF: Switch released
ON: Switch pushed
When the switch is built into the combination meter assembly or is connected via direct line, the input value is displayed.
Body Electrical > Combination Meter > Data List
Tester Display
Light Control Switch (UP)
Light Control Switch (DOWN)
50003 409 398,399
OK:

Light control rheostat up switch or down switch condition displayed on the GTS changes with the actual switch operation.



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

2.INSPECT TRIP SWITCH
2.INSPECT TRIP SWITCH

b.

Inspect the trip switch.

Click here

Click hereVehicle Interior>METER / GAUGE / DISPLAY>TRIP SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (TRIP SWITCH - COMBINATION METER ASSEMBLY)

NG

3.CHECK HARNESS AND CONNECTOR (TRIP SWITCH - COMBINATION METER ASSEMBLY)
a.

Disconnect the H22 combination meter assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H23-4 (RV) - H22-2 (TR) Always Below 1 Ω
H23-1 (E) - H22-5 (SW3) Always Below 1 Ω
H23-4 (RV) or H22-2 (TR) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR