A hybrid system indicator has been included on this vehicle. In this circuit, the combination meter assembly receives the hybrid system indicator signal from the hybrid vehicle control ECU via CAN communication. The combination meter assembly controls the operation of the hybrid system indicator according to the hybrid system indicator signal received from the hybrid vehicle control ECU via CAN communication.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
Check if CAN communication DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for HV Model)>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Check if hybrid control system DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
for 2WD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 2WD)>DIAGNOSTIC TROUBLE CODE CHART
for 4WD/AWD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 4WD/AWD)>DIAGNOSTIC TROUBLE CODE CHART
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| HV/EV System Indicator (MIN) | Hybrid system indicator value
(Charge area) |
ON | See [Display 1] |
| HV/EV System Indicator (-50%) | Hybrid system indicator value
(Charge area) |
ON | See [Display 1] |
| HV/EV System Indicator (0%) | Hybrid system indicator value
(Charge area) |
ON | See [Display 1] |
| HV/EV System Indicator (100%) | Hybrid system indicator value
(Eco area) |
ON | See [Display 1] |
| HV/EV System Indicator (200%) | Hybrid system indicator value
(Power area) |
ON | See [Display 1] |
| HV/EV System Indicator (300%) | Hybrid system indicator value
(Power area) |
ON | See [Display 1] |
| HV/EV System Indicator (400%) | Hybrid system indicator value
(Power area) |
ON | See [Display 1] |
| HV/EV System Indicator (MAX) | Hybrid system indicator value
(Power area) |
ON | See [Display 1] |
| *a | Hybrid System Indicator |
Refer to the following table for the specified hybrid system indicator position for each selected value:
| Tester Display | Hybrid System Indicator Indication |
|---|---|
| HV/EV System Indicator
(MIN) |
Approximately 1 is indicated |
| HV/EV System Indicator
(-50%) |
Approximately 2 is indicated |
| HV/EV System Indicator
(0%) |
Approximately 3 is indicated |
| HV/EV System Indicator
(100%) |
Approximately 4 is indicated |
| HV/EV System Indicator
(200%) |
Approximately 5 is indicated |
| HV/EV System Indicator
(300%) |
Approximately 6 is indicated |
| HV/EV System Indicator
(400%) |
Approximately 7 is indicated |
| HV/EV System Indicator
(MAX) |
Approximately 8 is indicated |
| Tester Display |
|---|
| HV System Indicator (MIN) |
| Tester Display |
|---|
| HV System Indicator (-50%) |
| Tester Display |
|---|
| HV System Indicator (0%) |
| Tester Display |
|---|
| HV System Indicator (100%) |
| Tester Display |
|---|
| HV System Indicator (200%) |
| Tester Display |
|---|
| HV System Indicator (300%) |
| Tester Display |
|---|
| HV System Indicator (400%) |
| Tester Display |
|---|
| HV System Indicator (MAX) |
Hybrid system indicator indication is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG