In this circuit, the combination meter assembly receives engine speed signals from the ECM via CAN communication. The combination meter assembly displays the engine speed calculated based on the data received from the ECM.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
Before replacing the ECM, refer to Service Bulletin.
Check if CAN communication DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN communication DTCs are not output | A |
| CAN communication DTCs are output | B |
A
B
Check if SFI system DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| TachoMeter Operation (0rpm) | Tachometer
(0 rpm) |
ON | - |
| TachoMeter Operation (1000rpm) | Tachometer
(1000 rpm) |
ON | - |
| TachoMeter Operation (2000rpm) | Tachometer
(2000 rpm) |
ON | - |
| TachoMeter Operation (3000rpm) | Tachometer
(3000 rpm) |
ON | - |
| TachoMeter Operation (4000rpm) | Tachometer
(4000 rpm) |
ON | - |
| TachoMeter Operation (5000rpm) | Tachometer
(5000 rpm) |
ON | - |
| TachoMeter Operation (6000rpm) | Tachometer
(6000 rpm) |
ON | - |
| TachoMeter Operation (7000rpm) | Tachometer
(7000 rpm) |
ON | - |
| TachoMeter Operation (8000rpm) | Tachometer
(8000 rpm) |
ON | - |
| Tester Display |
|---|
| TachoMeter Operation (0rpm) |
| Tester Display |
|---|
| TachoMeter Operation (1000rpm) |
| Tester Display |
|---|
| TachoMeter Operation (2000rpm) |
| Tester Display |
|---|
| TachoMeter Operation (3000rpm) |
| Tester Display |
|---|
| TachoMeter Operation (4000rpm) |
| Tester Display |
|---|
| TachoMeter Operation (5000rpm) |
| Tester Display |
|---|
| TachoMeter Operation (6000rpm) |
| Tester Display |
|---|
| TachoMeter Operation (7000rpm) |
| Tester Display |
|---|
| TachoMeter Operation (8000rpm) |
Tachometer indication is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG