Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › ECM › 2020.02–2020.11
RM37A0E _51 Engine / Hybrid System _086849 2GR-FKS ENGINE CONTROL _0418440 ECM A

2GR-FKS ENGINE CONTROL  ECM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ECM removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

*2: Not necessary when ECM replaced with new one

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Replacement of ECM Perform Vehicle Identification Number (VIN) or frame number registration DTC is output (Click here)
Code registration Engine start function See Service Bulletin for the registration method

If transaxle compensation code read from ECM

-

Perform reset memory*2

-

Transfer transaxle compensation code

-

Perform road test to allow ECM to learn



·

Large shift shock

·

Deterioration of fuel efficiency


for Initialization:(Click here)
for Registration:(Click here)

If transaxle compensation code not read from ECM

-

Perform reset memory*2

-

Reset transaxle compensation code

-

Perform road test to allow ECM to learn




NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.

·

If the ECM has been struck or dropped, replace it.

·

Perform Vehicle Identification Number (VIN) or frame number registration when replacing the ECM.

Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 53295E 2.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17750A 3.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 4.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 89661 5.REMOVE ECM

a.
A454777

Rotate the 2 levers while pushing the locks, and disconnect the 2 ECM connectors.

NOTICE:

After disconnecting the ECM connectors, make sure that dirt, water and other foreign matter does not contact the connecting parts of the ECM connectors.



b.
A454779

Remove the 2 bolts, nut and ECM.

NOTICE:

If the ECM has been struck or dropped, replace it.



Hide 89667E 6.REMOVE NO. 1 ECM BRACKET

a.
A454780

Remove the 2 screws and No. 1 ECM bracket from the ECM.


Hide 89668 7.REMOVE NO. 2 ECM BRACKET

a.
A454781

Remove the 2 screws and No. 2 ECM bracket from the ECM.