Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 2GR-FKS) › 2020.02–2020.11
RM37A0E _58 Vehicle Interior _086896 HEATING / AIR CONDITIONING _0417370 COMPRESSOR(for 2GR-FKS) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 2GR-FKS)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during compressor and magnetic clutch removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Front bumper assembly*
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Front television camera view adjustment Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 16400 2.REMOVE RADIATOR ASSEMBLY

Hide 16361A 3.REMOVE V-RIBBED BELT

Hide 88703 4.DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

a.
E431360

Remove the bolt and disconnect the discharge hose sub-assembly from the compressor and magnetic clutch.


b.

Remove the O-ring from the discharge hose sub-assembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



Hide 88704 5.DISCONNECT SUCTION HOSE SUB-ASSEMBLY

a.
E431361

Remove the bolt and disconnect the suction hose sub-assembly from the compressor and magnetic clutch.


b.

Remove the O-ring from the suction hose sub-assembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



Hide 6.REMOVE COMPRESSOR AND MAGNETIC CLUTCH

a.
E431362

Disconnect each connector.


b.

Disengage each clamp.


c.
E431363C01
2.021,1.677 2.594,1.448 true 2.594,1.354 2.771,1.531 0.177,0.177 10 true *a
*a Bracket
V100135

Bolt
V100136

Nut


Remove the 2 bolts and 2 nuts, and separate the bracket.


d.
E431364

Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor and magnetic clutch.