Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR › 2020.02–2020.11
RM37A0E _51 Engine / Hybrid System _086858 CRUISE CONTROL _0417632 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Dynamic Radar Cruise Control System (for HV model)

·

Lane Control System

·

Road Sign Assist System

·

Front Radar Sensor System

·

Pre-collision System

·

Lighting System (EXT)


(Click here)

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Dynamic Radar Cruise Control System (for Gasoline model)

·

Lane Control System

·

Road Sign Assist System

·

Front Radar Sensor System

·

Pre-collision System

·

Lighting System (EXT)


(Click here)

PROCEDURE

Hide 53295E 1.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 88211B 2.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

a.
E430640

Disconnect the connector.


b.
E430641C01
0,0 0,0 false
V100135

Bolt
V100136

Screw


Remove the 2 bolts and screw.


c.

Disengage the 2 guides and remove the millimeter wave radar sensor assembly.

NOTICE:

Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.