The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper assembly removal/installation are shown below.
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
53295E
1.REMOVE COOL AIR INTAKE DUCT SEAL
Remove the 9 clips and cool air intake duct seal.
75086
2.DISCONNECT FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY LH
|
Protective Tape |
Apply protective tape around the front fender wheel opening moulding sub-assembly LH.
Remove the 3 clips.
Remove the screw.
| *1 | Front Fender Liner LH |
|
Remove in this Direction |
Pull back the edge of the front fender liner LH and disengage the 4 claws by pushing the area indicated by the arrow in the illustration with a finger.
Do not apply excessive force when pulling back the front fender liner LH.
To avoid damaging the claws, do not forcibly pull the front fender wheel opening moulding sub-assembly LH.
Disengage the 2 clips and disconnect the front fender wheel opening moulding sub-assembly LH.
Remove the 2 clips from the front fender wheel opening moulding sub-assembly LH.
75085A
3.DISCONNECT FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
4.REMOVE FRONT BUMPER ASSEMBLY
|
Protective Tape |
Apply protective tape around the front bumper assembly.
Use the same procedure for the RH side and LH side.
Remove the 10 screws.
Remove the 4 bolts.
Disengage the 6 claws.
Use the same procedure for the RH side and LH side.
Disengage the claw to remove the front bumper assembly.
Disconnect each connector.
Use the same procedure for the LH side and RH side.
w/ Headlight Cleaner System:
Disconnect the No. 1 headlight cleaner washer hose assembly.
Drain the washer fluid.
Use a container to collect the washer fluid.