Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR › 2020.02–2020.11
RM37A0E _51 Engine / Hybrid System _086858 CRUISE CONTROL _0417632 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  INSTALLATION  


PROCEDURE

Hide 88211B 1.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

NOTICE:

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.


a.
E430641C02
2.792,0.979 2.917,1.156 0.125,0.177 10 true 1 0.427,0.948 0.552,1.125 0.125,0.177 10 true 2 1.771,0.167 1.896,0.344 0.125,0.177 10 true 3
V100135

Bolt
V100136

Screw


Engage the 2 guides.


b.

Install the millimeter wave radar sensor assembly with the 2 bolts and screw.

Torque:
Bolt : 2.5 N*m (25 kgf*cm, 22 in.*lbf)

HINT:

Tighten the bolts and screw in the order shown in the illustration.



c.

Connect the connector.


Hide 53295E 2.INSTALL COOL AIR INTAKE DUCT SEAL

Hide 3.ADJUST MILLIMETER WAVE RADAR SENSOR

a.

When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT