When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
1.INSTALL FRONT BUMPER ASSEMBLY
Move the front bumper assembly into position.
w/ Headlight Cleaner System:
Connect the No. 1 headlight cleaner washer hose assembly.
Connect each connector.
Engage the 13 claws.
Install the 4 bolts.
Install the front bumper assembly with the 10 screws.
Remove the protective tape.
75086
2.CONNECT FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY LH
Install 2 new clips to the front fender wheel opening moulding sub-assembly LH.
|
Install in this Direction |
Engage the 2 clips and 4 claws as shown in the illustration.
Connect the front fender liner LH with the screw and 3 clips.
Remove the protective tape.
75085A
3.CONNECT FRONT FENDER WHEEL OPENING MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
53295E
4.INSTALL COOL AIR INTAKE DUCT SEAL
Install the cool air intake duct seal with the 9 clips.
5.ADJUST FOG LIGHT ASSEMBLY
86790B
6.ADJUST FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
7.PERFORM CALIBRATION (w/ Parking Support Brake System)
8.ADD WASHER FLUID (w/ Headlight Cleaner System)