The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during antenna cord sub-assembly removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55846A
2.REMOVE NO. 4 HEATER TO REGISTER DUCT
86101J
3.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Navigation Antenna)
for Antenna Cord Sub-assembly without Branch Line:
Disconnect the connector and disengage the 2 claws.
| *A | w/ Navigation ECU | - | - |
Disengage each clamp and remove the No. 2 antenna cord sub-assembly.
for Antenna Cord Sub-assembly with Branch Line:
Disconnect the connector and disengage the 2 claws.
Disengage each clamp and remove the No. 2 antenna cord sub-assembly.
86101
4.REMOVE ANTENNA CORD SUB-ASSEMBLY
w/ Antenna Divider:
Disconnect the connector.
Disengage each clamp and remove the antenna cord sub-assembly.
| *A | for Antenna Cord Sub-assembly with Branch Line | - | - |
5.REMOVE ROOF HEADLINING ASSEMBLY
86101D
6.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY (for Normal Roof)
Remove the adhesive tape from the roof headlining assembly.
|
Adhesive Tape | - | - |
Remove the No. 3 antenna cord sub-assembly from the roof headlining assembly.
86101D
7.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY (for Moon Roof)
Remove the adhesive tape from the roof headlining assembly.
| *A | w/ Rear Seat Entertainment System | - | - |
|
Adhesive Tape | - | - |
Remove the No. 3 antenna cord sub-assembly from the roof headlining assembly.
86101D
8.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY (for Panoramic Moon Roof)
Remove the adhesive tape from the roof headlining assembly.
|
Adhesive Tape | - | - |
Remove the No. 3 antenna cord sub-assembly from the roof headlining assembly.
86101Q
9.REMOVE NO. 4 ANTENNA CORD SUB-ASSEMBLY
| *A | w/ Manual (SOS) Switch |
Disconnect the connector.
Disengage each clamp and remove the No. 4 antenna cord sub-assembly.