Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR › 2020.02–2020.11
RM37A0E _56 Audio / Visual / Telematics _086880 PARK ASSIST / MONITORING _0417855 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during blind spot monitor sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Rear bumper assembly*
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Blind spot monitor sensor Blind spot monitor beam axis adjustment
·

TOYOTA Parking Assist-sensor System (w/ Parking Support Brake System)

·

TOYOTA Parking Assist-sensor System (w/o Parking Support Brake System)

·

Parking Support Brake System

·

Blind Spot Monitor System


(Click here)

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Rear bumper assembly*
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking Support Brake System (Click here)
Blind spot monitor sensor Blind spot monitor beam axis adjustment
·

TOYOTA Parking Assist-sensor System (w/ Parking Support Brake System)

·

TOYOTA Parking Assist-sensor System (w/o Parking Support Brake System)

·

Parking Support Brake System

·

Blind Spot Monitor System


(Click here)

PROCEDURE

Hide 1.REMOVE REAR BUMPER ASSEMBLY

Hide 88172 2.REMOVE BLIND SPOT MONITOR SENSOR LH

a.
E432181

Disconnect the connector.


b.

Remove the 3 nuts and blind spot monitor sensor LH.

NOTICE:

Replace the blind spot monitor sensor LH if it has been dropped or subjected to a severe impact.



Hide 88162 3.REMOVE BLIND SPOT MONITOR SENSOR RH

a.
E432182

Disconnect the connector.


b.

Remove the 3 nuts and blind spot monitor sensor RH.

NOTICE:

Replace the blind spot monitor sensor RH if it has been dropped or subjected to a severe impact.