The main body ECU (multiplex network body ECU) and rain sensor communicate via LIN communication. The main body ECU (multiplex network body ECU) stores this DTC if communication becomes abnormal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from |
|---|---|---|---|---|---|
| B1279 | Lost Communication with Humidity/Rain Sensor LIN | Detection Condition:
Auxiliary battery voltage is 9.5 V or more Malfunction Status:
Communication malfunction with rain sensor Malfunction Duration:
10 seconds or more |
·
Rain sensor ·
Harness or connector ·
Main body ECU (multiplex network body ECU) |
○ | Main body ECU (multiplex network body ECU) |
Inspect the fuses of circuits related to this system before performing the following procedure.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Read the DTCs.
| Result | Proceed to |
|---|---|
| Only DTC B1279 is output | A |
| DTC B1279 and B1373 are output | B |
A
B
Disconnect the H42 main body ECU (multiplex network body ECU) connector.
Disconnect the R4 rain sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H42-3 (LIN3) - R4-3 (MPX) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Main Body ECU (Multiplex Network Body ECU) |
Check for voltage and pulses according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H42-3 (LIN3) - Body ground | Ignition switch ON | Pulse generation |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Rain Sensor) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R4-4 (SIG) - Body ground | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Rain Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R4-2 (ES) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG