Home › Steering › STEERING COLUMN › STEERING WHEEL › 2020.02–2020.11
RM37A0E _55 Steering _086875 STEERING COLUMN _0418169 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not remove/install the spiral cable with sensor sub-assembly with the auxiliary battery connected and the ignition switch ON.

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the auxiliary battery connected and the ignition switch ON.

·

Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.



PROCEDURE

Hide 84250A 1.INSTALL STEERING PAD SWITCH ASSEMBLY

Hide 2.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 3.INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 4.INSTALL STEERING WHEEL ASSEMBLY

a.
C431434C01
1.75,1.104 0.771,1.115 0.771,1.115 1.75,1.146 true 0.573,1.031 0.76,1.198 0.188,0.167 10 true *a
*a Matchmark


Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.


b.

Using a 10 mm hexagon socket wrench, install the steering wheel assembly set bolt.

Torque:
62 N*m (632 kgf*cm, 46 ft.*lbf)


c.

Connect each connector.


Hide 5.CHECK STEERING WHEEL CENTER POINT

Hide 45130 6.INSTALL HORN BUTTON ASSEMBLY