The side collision sensor LH circuit (bus 1) consists of the airbag sensor assembly, side airbag sensor assembly LH and rear airbag sensor LH.
The side airbag sensor assembly LH and rear airbag sensor LH detect impacts to the vehicle and send signals to the airbag sensor assembly to determine if the airbags and pretensioners should be deployed.
These DTCs are stored when a malfunction is detected in the side airbag sensor assembly LH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Test Mode / Check Mode |
|---|---|---|---|---|---|
| B167A | Front Door Pressure Sensor LH | ·
Side airbag sensor assembly LH malfunction ·
Airbag sensor assembly malfunction |
·
Side airbag sensor assembly LH ·
Airbag sensor assembly |
Comes on | Does not apply to test/check mode |
| B167E | Front Door Pressure Sensor Threshold Malfunction (LH) | ·
Side airbag sensor assembly LH malfunction ·
Airbag sensor assembly malfunction |
·
Side airbag sensor assembly LH ·
Airbag sensor assembly |
Comes on | Does not apply to test/check mode |
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
| *1 | Side Airbag Sensor Assembly RH |
| *2 | Rear Airbag Sensor LH |
Turn the ignition switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Interchange the side airbag sensor assembly LH with RH and connect the connectors.
Connect the cable to the negative (-) auxiliary battery terminal.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in memory.
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs.
Codes other than DTCs B166C, B166F, B167A and B167E may be output at this time, but they are not related to this check.
| Result | Proceed to |
|---|---|
| DTC B167A or B167E is output. | A |
| DTC B166C or B166F is output. | B |
| DTCs B166C, B166F, B167A and B167E are not output. | C |
Turn the ignition switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Return the side airbag sensor assembly LH and RH to their original positions and connect the connectors.
A
B
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING