The No. 2 skid control ECU (brake actuator assembly) sends signals such as brake request signals to the hybrid vehicle control ECU. If an abnormal signal is detected, the hybrid vehicle control ECU stores DTC P163081.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| P163081 | Communication Error from VSC to ECM Invalid Serial Data Received | w/ Full-speed Range Following Function:
·
When the dynamic radar cruise control system is operating, the hybrid vehicle control ECU detects abnormal data sent from the No. 2 skid control ECU (brake actuator assembly) for approximately 1 second or more. w/o Full-speed Range Following Function: ·
When the vehicle speed is 30 km/h (20 mph) or more and the dynamic radar cruise control system is operating, the hybrid vehicle control ECU detects abnormal data sent from the No. 2 skid control ECU (brake actuator assembly) for approximately 1 second or more. |
·
Electronically controlled brake system ·
Hybrid vehicle control ECU |
Cruise Control |
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
Check for electronically controlled brake system DTCs.
| Result | Proceed to |
|---|---|
| Electronically controlled brake system DTCs are not output | A |
| Electronically controlled brake system DTCs are output | B |
A
B
Clear the DTCs.
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC P163081 is not output | A |
| DTC P163081 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B