This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.INSTALL O-RING
Perform this procedure only when replacement of the O-ring is necessary.
Clean the O-ring groove of the cam timing oil control solenoid assembly.
Make sure the O-ring groove is free of foreign matter.
Install a new O-ring to the cam timing oil control solenoid assembly.
Do not damage the O-ring when installing it.
15370
2.INSTALL CAM TIMING OIL CONTROL SOLENOID ASSEMBLY
Apply a light coat of engine oil to the O-ring of the cam timing oil control solenoid assembly.
If reusing the cam timing oil control solenoid assembly, be sure to inspect the O-ring.
Using an 8 mm socket wrench, install the cam timing oil control solenoid assembly to the No. 2 timing gear cover assembly with 2 new bolts.
If the cam timing oil control solenoid assembly has been struck or dropped, replace it.
Make sure that the O-ring is not cracked or moved out of place when installing the cam timing oil control solenoid assembly.
Connect the cam timing oil control solenoid assembly connector.
82286A
3.INSTALL NO. 2 EARTH WIRE
Install the No. 2 earth wire to the engine mounting insulator sub-assembly RH with the bolt.
4.INSPECT FOR ENGINE OIL LEAK
12601B
5.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY