The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ECM removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
If the ECM has been struck or dropped, replace it.
Perform Vehicle Identification Number (VIN) registration when replacing the ECM.
Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION
58441L
1.REMOVE BATTERY SERVICE HOLE COVER
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
89661
3.REMOVE ECM
Rotate the 2 levers while pushing the locks, and disconnect the 2 ECM connectors.
After disconnecting the ECM connectors, make sure that dirt, water and other foreign matter does not contact the connecting parts of the ECM connectors.
Remove the bolt and separate the engine wire from the No. 1 ECM bracket.
Disengage the clamp.
Remove the bolt, 2 nuts and ECM.
If the ECM has been struck or dropped, replace it.
89667E
4.REMOVE NO. 1 ECM BRACKET
Remove the 2 screws and No. 1 ECM bracket from the ECM.
89668
5.REMOVE NO. 2 ECM BRACKET
Remove the 2 screws and No. 2 ECM bracket from the ECM.