The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.DRAIN ENGINE COOLANT (for Engine)
G9200
2.REMOVE INVERTER WITH CONVERTER ASSEMBLY
89422A
3.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
Disconnect the engine coolant temperature sensor connector.
Remove the clip and engine coolant temperature sensor from the water outlet.
If the engine coolant temperature sensor has been struck or dropped, replace it.