Home › Engine / Hybrid System › A25A-FXS, A25B-FXS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 1)
RM37A0E _51 Engine / Hybrid System _086905 A25A-FXS, A25B-FXS ENGINE CONTROL _0418428 AIR FUEL RATIO SENSOR(for Sensor 1) A

A25A-FXS, A25B-FXS ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 1)  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A454952C01
0.906,0.969 1.323,0.969 true 2.198,0.208 2.438,0.396 0.24,0.188 10 true *a 0.542,0.885 0.885,1.073 0.344,0.188 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor to the exhaust manifold (TWC: Front Catalyst).

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

37.7 N*m (384 kgf*cm, 28 ft.*lbf)




b.
A454953C01
2.74,0.542 2.115,0.219 2.115,0.219 2.188,0.688 true 2.365,0.823 2.583,0.99 2.583,0.99 2.74,0.74 true 1.906,0.104 2.094,0.313 0.188,0.208 10 true *a 2.5,1.01 2.719,1.188 0.219,0.177 10 true *b
*a Wire Harness Clamp
*b Tie Band


Connect the air fuel ratio sensor connector.


c.

Engage the 3 wire harness clamps so that the tie bands are positioned as shown in the illustration.


Hide 12601B 2.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 4.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION