Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR
RM37A0E _51 Engine / Hybrid System _086849 2GR-FKS ENGINE CONTROL _0418443 CAMSHAFT POSITION SENSOR A

2GR-FKS ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during VVT sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Perform Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 17190 1.REMOVE INTAKE AIR SURGE TANK ASSEMBLY

Hide 2.REMOVE VVT SENSOR (for Intake Side of Bank 1)

a.
A454791

Disconnect the VVT sensor connector.


b.

Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.

NOTICE:

If the VVT sensor has been struck or dropped, replace it.



Hide 3.REMOVE VVT SENSOR (for Exhaust Side of Bank 1)

a.
A454792

Disconnect the VVT sensor connector.


b.

Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.

NOTICE:

If the VVT sensor has been struck or dropped, replace it.



Hide 4.REMOVE VVT SENSOR (for Intake Side of Bank 2)

a.
A454793

Disconnect the VVT sensor connector.


b.

Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH.

NOTICE:

If the VVT sensor has been struck or dropped, replace it.



Hide 5.REMOVE VVT SENSOR (for Exhaust Side of Bank 2)

a.
A454794

Disconnect the VVT sensor connector.


b.

Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH.

NOTICE:

If the VVT sensor has been struck or dropped, replace it.