The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during park/neutral position switch assembly adjustment are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
If the ECM has been struck or dropped, replace it.
Perform Vehicle Identification Number (VIN) or frame number registration when replacing the ECM.
Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION
Before adjusting the park/neutral position switch assembly, check that the shift lever is in N.
1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
33820B
2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
84540
3.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Disengage the wire harness clamp.
Disconnect the park/neutral position switch assembly connector.
Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.
Loosen the 2 bolts of the park/neutral position switch assembly.
| *a | Neutral Basic Line |
| *b | Protrusion |
Align the protrusion with the neutral basic line.
Hold the park/neutral position switch assembly in position and tighten the 2 bolts.
Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.
Connect the park/neutral position switch assembly connector.
Engage the wire harness clamp.
33820B
4.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
84540
5.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION