The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during park/neutral position switch assembly removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
If the ECM has been struck or dropped, replace it.
Perform Vehicle Identification Number (VIN) or frame number registration when replacing the ECM.
Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION
Before removing the park/neutral position switch assembly, check that the shift lever is in N.
1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
2.REMOVE BATTERY
89661
3.REMOVE ECM
74404B
4.REMOVE BATTERY CLAMP SUB-ASSEMBLY
33820B
5.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
| *a | Clip (A) |
| *b | 45° to 60° |
| *c | Clip (B) |
While disengaging the clip (A) as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever together with the clip (A).
Remove the clip (B) and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
84540
6.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Disengage the wire harness clamp.
Disconnect the park/neutral position switch assembly connector.
Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.
Remove the 2 bolts and park/neutral position switch assembly from the automatic transaxle case sub-assembly.
Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the manual valve lever shaft sub-assembly. Be sure to remove the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.