The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft oil seal LH removal/installation are shown below.
43420
1.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
43420H
2.REMOVE FRONT DRIVE SHAFT OIL SEAL LH
Using SST, remove the front drive shaft oil seal LH from the automatic transaxle case sub-assembly.
Do not damage the automatic transaxle case sub-assembly.
43420H
3.INSTALL FRONT DRIVE SHAFT OIL SEAL LH
| *a | Depth |
Using SST and a hammer, install a new front drive shaft oil seal LH to the automatic transaxle case sub-assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Be sure to install the front drive shaft oil seal LH in the correct direction.
Make sure to install the front drive shaft oil seal LH as specified, otherwise malfunctions such as a fluid leak will occur.
Do not damage the lip of the front drive shaft oil seal LH.
43420
4.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH