Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
67848E
1.REMOVE BACK DOOR SERVICE HOLE COVER LH
67847
2.REMOVE BACK DOOR SERVICE HOLE COVER RH
Use the same procedure as for the LH side.
64780A
3.REMOVE BACK DOOR TRIM PANEL ASSEMBLY
68920
4.REMOVE POWER BACK DOOR UNIT SET ASSEMBLY
| *a | Grommet |
Disconnect the connector.
Disengage the grommet.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the 2 stop rings as shown in the illustration.
Disengage the 2 ball joints to remove the power back door unit set assembly.
Remove the power back door unit set assembly while supporting the back door by hand.
Make sure to replace the power back door unit set assembly with a new one.
68946
5.REMOVE BACK DOOR DAMPER STAY UPPER BRACKET
Remove the 2 bolts and back door damper stay upper bracket.
68948
6.REMOVE BACK DOOR DAMPER STAY LOWER BRACKET
Remove the 2 bolts and back door damper stay lower bracket.
Remove the 2 bushes.
68984
7.REMOVE BACK DOOR STAY STOPPER
Perform this procedure only when replacement of the back door stay stopper is necessary.
Disengage the 2 claws to remove the back door stay stopper.