Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
68984
1.INSTALL BACK DOOR STAY STOPPER
Perform this procedure only when replacement of the back door stay stopper is necessary.
Engage the 2 claws to install the back door stay stopper.
68948
2.INSTALL BACK DOOR DAMPER STAY LOWER BRACKET
Install the 2 bushes.
Install the back door damper stay lower bracket with the 2 bolts.
68946
3.INSTALL BACK DOOR DAMPER STAY UPPER BRACKET
Clean the 2 bolt holes of the vehicle body.
Apply adhesive to the threads of the 2 bolts.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the back door damper stay upper bracket with the 2 bolts.
68920
4.INSTALL POWER BACK DOOR UNIT SET ASSEMBLY
Do not apply any horizontal load to the power back door unit set assembly in order to prevent it from deforming.
Engage the 2 ball joints to install the power back door unit set assembly.
Install the power back door unit set assembly while supporting the back door by hand.
Check that the power back door unit set assembly is engaged to the ball joints and that it cannot be pulled out.
Engage the grommet.
Connect the connector.
64780A
5.INSTALL BACK DOOR TRIM PANEL ASSEMBLY
67848E
6.INSTALL BACK DOOR SERVICE HOLE COVER LH
67847
7.INSTALL BACK DOOR SERVICE HOLE COVER RH
Use the same procedure as for the LH side.
8.INITIALIZE POWER BACK DOOR SYSTEM
9.ADJUST BACK DOOR
When the back door upper stopper cushion or back door damper stay lower bracket is removed, it is necessary to perform back door position adjustment.
Click hereVehicle Exterior>DOOR / HATCH>BACK DOOR>ADJUSTMENT