Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR CLOSER ECU
RM37A0E _59 Vehicle Exterior _086885 DOOR / HATCH _0418608 BACK DOOR CLOSER ECU A

DOOR / HATCH  BACK DOOR CLOSER ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during multiplex network door ECU removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Multiplex network door ECU* Reset back door close position Power Back Door System (Click here)

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

Multiplex network door ECU* Reset back door close position Power Back Door System (Click here)

NOTICE:

When replacing the multiplex network door ECU, the back door automatic open stop position (memory stopped position) must be registered, so be sure to make a note of the automatic open stop position.


PROCEDURE

Hide 67848E 1.REMOVE BACK DOOR SERVICE HOLE COVER LH

Hide 67847 2.REMOVE BACK DOOR SERVICE HOLE COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 64780A 3.REMOVE BACK DOOR TRIM PANEL ASSEMBLY

Hide 89222A 4.REMOVE MULTIPLEX NETWORK DOOR ECU

a.
B563375C01
0,0 0,0 false

Remove the 2 bolts.


b.

Disengage the 2 guides.


c.
B563376

Disconnect the 2 connectors to remove the multiplex network door ECU.