Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for 8 Inch Display)
RM37A0E _56 Audio / Visual / Telematics _086878 NAVIGATION / MULTI INFO DISPLAY _0418790 NAVIGATION SYSTEM(for 8 Inch Display) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for 8 Inch Display)  AVC-LAN Circuit  


DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transmits signals via AVC-LAN communication.

If a short to +B or short to ground occurs in an AVC-LAN communication line, the navigation system will not function normally because communication is not possible.

WIRING DIAGRAM

E323016E05
0.906,3.396 2.958,3.615 2.052,0.219 10 false : AVC-LAN Communication Line 4.677,2.896 7.135,3.229 2.458,0.333 10 false Radio and Display Receiver Assembly 4.677,2.719 5,2.927 0.323,0.208 10 false H1 1.052,0.969 1.417,1.188 0.365,0.219 10 false M38 1.052,1.135 3.719,1.396 2.667,0.26 10 false Stereo Component Amplifier Assembly*1 1.365,2.677 1.688,2.885 0.323,0.208 10 false R16 1.365,2.854 3.323,3.146 1.958,0.292 10 false Television Display Assembly*2 5.24,0.323 5.854,0.521 0.615,0.198 10 false TX1+ 5.24,0.719 5.854,0.917 0.615,0.198 10 false TX1- 5.24,2.021 5.854,2.219 0.615,0.198 10 false TX+ 5.25,2.417 5.865,2.615 0.615,0.198 10 false TX- 5.042,0.188 5.365,0.396 0.323,0.208 10 false 5 5.042,0.583 5.365,0.792 0.323,0.208 10 false 6 4.969,1.875 5.292,2.083 0.323,0.208 10 false 19 4.969,2.271 5.292,2.479 0.323,0.208 10 false 20 2.719,0.188 3.042,0.396 0.323,0.208 10 false 8 2.719,0.594 3.042,0.802 0.323,0.208 10 false 7 2.719,1.885 3.042,2.094 0.323,0.208 10 false 4 2.719,2.281 3.042,2.49 0.323,0.208 10 false 5 2.396,0.323 2.771,0.521 0.375,0.198 10 false TX+ 2.417,0.719 2.792,0.917 0.375,0.198 10 false TX- 2.302,2.01 2.677,2.208 0.375,0.198 10 false TX1+ 2.333,2.406 2.708,2.604 0.375,0.198 10 false TX1- 3.625,3.479 6.427,3.729 2.802,0.25 10 false *2: w/ Rear Seat Entertainment System 3.625,3.219 6.583,3.5 2.958,0.281 10 false *1: w/ Stereo Component Amplifier Assembly


CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for 8 Inch Display)>PRECAUTION


HINT:

The radio and display receiver assembly is the master unit.


PROCEDURE

1.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY
a.

Remove the radio and display receiver assembly.


b.
E394515C25
1.583,0.813 1.99,1.031 0.406,0.219 2.406,2.865 2.635,1.813 false 3,2.854 2.771,1.813 false 1.865,2.51 2.49,1.99 false 1.281,2.5 2.177,2 false 1.688,0.844 2,1.042 0.313,0.198 10 false H1 2.031,2.948 2.615,3.198 0.583,0.25 10 false TX1- (*A) 2.75,2.958 3.375,3.188 0.625,0.229 10 false TX1+ (*A) 0.188,0.167 0.5,0.365 0.313,0.198 10 false *a 1.604,2.563 2.208,2.771 0.604,0.208 10 false TX+ (*B) 1.021,2.542 1.594,2.781 0.573,0.24 10 false TX- (*B)
*A w/ Stereo Component Amplifier Assembly
*B w/ Rear Seat Entertainment System
*a Component without harness connected
(Radio and Display Receiver Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H1-5 (TX1+) - H1-6 (TX1-)*1 Always 60 to 80 Ω
H1-19 (TX+) - H1-20 (TX-)*2 Always 60 to 80 Ω


*1: w/ Stereo Component Amplifier Assembly

*2: w/ Rear Seat Entertainment System



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)
a.

Disconnect the H1 radio and display receiver assembly connector.


b.

Disconnect the M38 stereo component amplifier assembly connector (w/ Stereo Component Amplifier Assembly).


c.

Disconnect the R16 television display assembly connector (w/ Rear Seat Entertainment System).


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
M38-8 (TX+) - H1-5 (TX1+)*1 Always Below 1 Ω
M38-7 (TX-) - H1-6 (TX1-)*1 Always Below 1 Ω
M38-8 (TX+) or H1-5 (TX1+) - Body ground*1 Always 10 kΩ or higher
M38-7 (TX-) or H1-6 (TX1-) - Body ground*1 Always 10 kΩ or higher
R16-4 (TX1+) - H1-19 (TX+)*2 Always Below 1 Ω
R16-5 (TX1-) - H1-20 (TX-)*2 Always Below 1 Ω
R16-4 (TX1+) or H1-19 (TX+) - Body ground*2 Always 10 kΩ or higher
R16-5 (TX1-) or H1-20 (TX-) - Body ground*2 Always 10 kΩ or higher


*1: w/ Stereo Component Amplifier Assembly

*2: w/ Rear Seat Entertainment System



Result:
Proceed to
OK
NG



OK

3.INSPECT MALFUNCTIONING PARTS

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT MALFUNCTIONING PARTS
a.

Disconnect and reconnect each slave unit one by one until the master unit returns to normal.

HINT:
·

Check all slave units.

·

If disconnecting a slave unit causes the master unit to return to normal, the slave unit is defective and should be replaced.



OK:

Master unit returns to normal.



Result:
Proceed to
OK
NG



OK

REPLACE MALFUNCTIONING PARTS

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY