The ECM communicates with the generator assembly via LIN communication. If a LIN communication error is detected, the ECM stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Memory | Note |
|---|---|---|---|---|---|---|
| P161A87 | Lost Communication with Alternator Missing Message | Generator assembly or ECM communication stops for approximately 17 minutes or more with the ignition switch to ON.
(1 trip detection logic) |
·
Wire harness and connector ·
Generator assembly ·
ECM |
Charge warning is not displayed | DTC stored | SAE Code: P161A |
| Result |
|---|
| OK |
| NG |
OK
NG
Disconnect the C54 ECM connector.
Disconnect the C57 generator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C54-135 (LIN) - C57-2 (LIN) | Always | Below 1 Ω |
| C54-135 (LIN) or C57-2 (LIN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG