The rack and pinion power steering gear assembly uses waterproof connectors. Therefore, voltage or waveforms cannot be checked with the connectors connected to the vehicle.
Use the Data List and Active Test on the GTS to check the operation of the rack and pinion power steering gear assembly and check that communication is established.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST
CHECK WIRE HARNESS SIDE CONNECTOR
Disconnect the C67 rack and pinion power steering gear assembly connector and measure the voltage or resistance on the wire harness side.
| *a | Front view of wire harness connector
(to Rack and Pinion Power Steering Gear Assembly) |
- | - |
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| C67-4 (IG) - Body ground | IG power source | Ignition switch ON | 8 to 16 V |
| C67-7 (PGND) - Body ground | Power ground | Always | Below 1 Ω |
| C67-8 (PIG) - Body ground | Power source | Always | 9 to 16 V |
| C67-10 (CANH) | CAN communication line | - | - |
| C67-11 (CANL) | CAN communication line | - | - |