Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING (for Moon Roof) › 2020.02–2020.11
RM37A0E _59 Vehicle Exterior _086900 SLIDING ROOF / CONVERTIBLE _0419685 SLIDING ROOF HOUSING(for Moon Roof) A

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF HOUSING(for Moon Roof)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof housing removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

*1: Learning can also be performed using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Sliding roof ECU (Sliding roof drive gear assembly)* Initialize sliding roof system
·

Auto operation function

·

Jam protection function

·

Key-off operation function

·

Key-linked function

·

Wireless transmitter-linked function

·

Sliding roof open warning function


(Click here)
Initialize panoramic moon roof system (Sliding roof)
·

Auto operation function

·

Jam protection function

·

Key-off operation function

·

Sliding roof open warning function


(Click here)
Sliding roof glass sub-assembly (for Moon Roof)* Initialize sliding roof system
·

Auto operation function

·

Jam protection function

·

Key-off operation function

·

Key-linked function

·

Wireless transmitter-linked function

·

Sliding roof open warning function


(Click here)
Initialize panoramic moon roof system (Sliding roof)
·

Auto operation function

·

Jam protection function

·

Key-off operation function

·

Sliding roof open warning function


(Click here)
Sliding roof housing assembly (for Moon Roof)* Initialize panoramic moon roof system (Sliding roof)
·

Auto operation function

·

Jam protection function

·

Key-off operation function

·

Sliding roof open warning function


(Click here)

CAUTION:
B401522

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

*1: Learning can also be performed using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Sliding roof ECU (Sliding roof drive gear assembly)* Initialize sliding roof system
·

Auto operation function

·

Jam protection function

·

Key-off operation function

·

Key-linked function

·

Wireless transmitter-linked function

·

Sliding roof open warning function


(Click here)
Initialize panoramic moon roof system (Sliding roof)
·

Auto operation function

·

Jam protection function

·

Key-off operation function

·

Sliding roof open warning function


(Click here)
Sliding roof glass sub-assembly (for Moon Roof)* Initialize sliding roof system
·

Auto operation function

·

Jam protection function

·

Key-off operation function

·

Key-linked function

·

Wireless transmitter-linked function

·

Sliding roof open warning function


(Click here)
Initialize panoramic moon roof system (Sliding roof)
·

Auto operation function

·

Jam protection function

·

Key-off operation function

·

Sliding roof open warning function


(Click here)
Sliding roof housing assembly (for Moon Roof)* Initialize panoramic moon roof system (Sliding roof)
·

Auto operation function

·

Jam protection function

·

Key-off operation function

·

Sliding roof open warning function


(Click here)

CAUTION:
B401522

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 63218G 1.REMOVE SLIDING ROOF SIDE GARNISH LH

a.
B565135

Disengage the 2 claws to remove the sliding roof side garnish LH.


Hide 63217G 2.REMOVE SLIDING ROOF SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 63201G 3.REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY

a.

Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.

B565676

NOTICE:

To prevent the sliding roof glass sub-assembly and sliding roof drive gear sub-assembly from being displaced, fully close the sliding roof glass sub-assembly (sliding roof drive cable sub-assembly), and then remove the sliding roof glass sub-assembly.



Hide 62180A 4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

Hide 62170A 5.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 6.DISCONNECT SLIDING ROOF DRAIN HOSE

a.
B565137

for Clamp Type:

i.

Disengage the claw and disconnect the sliding roof drain hose.

HINT:

Use the same procedure for the other 3 sliding roof drain hoses.




b.
B565138

for Clip Type:

i.

Expand the clip and disconnect the sliding roof drain hose.

HINT:

Use the same procedure for the other 3 sliding roof drain hoses.




Hide 86291 7.REMOVE TELEVISION BRACKET (w/ Rear Seat Entertainment System)

a.
B565677

Remove the 4 bolts.


b.

Disengage the clip and 2 guides to remove the television bracket.


Hide 8.REMOVE SLIDING ROOF HOUSING ASSEMBLY

B565140

a.

Remove the 10 bolts, 6 nuts and sliding roof housing assembly.