Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for ERA-GLONASS)
RM37A0E _56 Audio / Visual / Telematics _086879 TELEMATICS _0419698 TELEMATICS SYSTEM(for ERA-GLONASS) C

TELEMATICS  TELEMATICS SYSTEM(for ERA-GLONASS)  B15C5  Emergency Switch Error (Open or Short)  


DESCRIPTION

This DTC is stored when the telematics transceiver detects an open or short circuit in the manual (SOS) switch.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C5 Emergency Switch Error (Open or Short) Open or short circuit in the manual (SOS) switch is detected
·

Telematics transceiver

·

Map light assembly (manual (SOS) switch)

·

Harness or connector



WIRING DIAGRAM

E342833E29
1.229,1.729 1.688,1.927 0.458,0.198 10 false R11 1.219,1.906 4.271,2.646 3.052,0.74 10 false Map Light Assembly (Manual (SOS) Switch) 5.115,1.729 5.729,1.927 0.615,0.198 10 false H10 5.115,1.906 6.625,2.115 1.51,0.208 10 false Telematics Transceiver 3,0.521 3.615,0.719 0.615,0.198 10 false SIG1 5.156,0.646 5.771,0.844 0.615,0.198 10 false SIG1 2.927,1.073 3.542,1.271 0.615,0.198 10 false GND3 5.156,1.083 5.771,1.281 0.615,0.198 10 false SIG- 3.406,0.521 3.583,0.719 0.177,0.198 10 false 7 3.406,1.073 3.625,1.302 0.219,0.229 10 false 1 4.927,0.521 5.24,0.719 0.313,0.198 10 false 27 4.917,1.083 5.229,1.281 0.313,0.198 10 false 26

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>REGISTRATION


PROCEDURE

1.CHECK DTC
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON and wait for 10 seconds or more.


d.

Turn the GTS on.


e.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 233

f.

Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH)
2.INSPECT MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH)
a.

Remove the map light assembly (manual (SOS) switch).

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL


b.
E430891C06
2.885,1.135 3.01,0.698 true 1.021,1.146 0.969,0.729 true 0.115,0.094 0.385,0.313 0.271,0.219 10 false *a 2.865,0.5 3.375,0.781 0.51,0.281 10 false GND3 0.813,0.531 1.229,0.74 0.417,0.208 10 false SIG1
*a Component without harness connected
(Map Light Assembly (Manual (SOS) Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
7 (SIG1) - 1 (GND3) Manual (SOS) switch not pressed 392 to 432 Ω
7 (SIG1) - 1 (GND3) Manual (SOS) switch pressed 78 to 86 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH))

NG

REPLACE MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH)

3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAP LIGHT ASSEMBLY (MANUAL (SOS) SWITCH))
a.

Disconnect the H10 telematics transceiver connector.


b.

Disconnect the R11 map light assembly (manual (SOS) switch) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H10-27 (SIG1) - R11-7 (SIG1) Always Below 1 Ω
H10-26 (SIG-) - R11-1 (GND3) Always Below 1 Ω
H10-27 (SIG1) or R11-7 (SIG1) - Body ground Always 10 kΩ or higher
H10-26 (SIG-) or R11-1 (GND3) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.REPLACE TELEMATICS TRANSCEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT