This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
89491
1.INSTALL ENGINE OIL LEVEL SENSOR
Using an 8 mm socket wrench, install the engine oil level sensor to the engine balancer assembly with the 2 bolts.
Install a new clip to the engine oil level sensor.
Connect the engine oil level sensor connector.
12102A
2.INSTALL NO. 2 OIL PAN SUB-ASSEMBLY
3.ADD ENGINE OIL
4.INSPECT FOR ENGINE OIL LEAK
5.CHECK ENGINE OIL LEVEL
51420
6.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
| *a | Bolt |
Install the No. 2 engine under cover assembly with the 4 bolts, 2 screws and 6 clips.