Home › Engine / Hybrid System › 2GR-FKS (LUBRICATION) › ENGINE OIL COOLER
RM37A0E _51 Engine / Hybrid System _086856 2GR-FKS LUBRICATION _0419966 ENGINE OIL COOLER A

2GR-FKS LUBRICATION  ENGINE OIL COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during oil cooler assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of air fuel ratio sensor

·

Gas leak from exhaust system is repaired


Perform Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 17150 3.REMOVE EXHAUST MANIFOLD ASSEMBLY LH (TWC: Front Catalyst)

Hide 15710 4.REMOVE OIL COOLER ASSEMBLY

a.
A368176

Remove the nut and hose clamp.


b.
A368177C01
1.125,0.302 1.344,0.302 1.344,0.302 1.708,0.698 true 1.948,1.042 2.396,1.396 2.396,1.396 2.688,1.396 true 0.938,0.219 1.135,0.417 0.198,0.198 10 true *1 2.729,1.281 2.917,1.5 0.188,0.219 10 true *2
*1 No. 4 Water By-pass Hose
*2 No. 5 Water By-pass Hose


Slide the 2 clips and disconnect the No. 4 water by-pass hose and No. 5 water by-pass hose from the oil cooler assembly.


c.
A368178

Remove the 2 bolts, 2 nuts and oil cooler assembly.


d.
A368179C02
1.833,0.875 2.375,0.875 true 0.667,1.094 1.271,1.094 true 1.823,1.396 2.208,1.396 2.208,1.396 2.208,0.885 true 2.375,0.771 2.594,0.958 0.219,0.188 10 true *1 0.448,1.021 0.656,1.198 0.208,0.177 10 true *2
*1 O-Ring
*2 No. 1 Cylinder Block Insulator


Remove the 2 O-rings and No. 1 cylinder block insulator.