Home › Power Source / Network › A25A-FXS, A25B-FXS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR
RM37A0E _57 Power Source / Network _086913 A25A-FXS, A25B-FXS BATTERY / CHARGING _0419979 BATTERY CURRENT SENSOR A

A25A-FXS, A25B-FXS BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery state sensor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 58441L 1.REMOVE BATTERY SERVICE HOLE COVER

Hide 28850C 2.REMOVE BATTERY STATE SENSOR ASSEMBLY

a.
A454866

Remove the nut and disconnect the No. 2 frame wire from the battery state sensor assembly.

NOTICE:

When disconnecting the No. 2 frame wire, some systems need to be initialized after the No. 2 frame wire is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



b.
A454867

Loosen the nut and remove the battery state sensor assembly from the auxiliary battery.


c.
A454868

Disconnect the battery state sensor assembly connector.


d.

Disengage the wire harness clamp.


e.
A454873

Disengage the 4 claws to remove the battery state sensor assembly from the battery current sensor holder.