Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM37A0E _56 Audio / Visual / Telematics _086880 PARK ASSIST / MONITORING _0420015 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1AB8  Destination Information Undefined  


DESCRIPTION

This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor sensor has been replaced.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AB8 Destination Information Undefined The blind spot monitor sensor cannot communicate with the main body ECU
·

CAN communication system

·

Main body ECU (multiplex network body ECU)

·

Blind spot monitor sensor LH (master)

·

Blind spot monitor sensor RH (slave)



CAUTION / NOTICE / HINT

NOTICE:
·

When checking for DTCs, make sure that the blind spot monitor system is turned on.

·

Before replacing the main body ECU (multiplex network body ECU), refer to the Service Bulletin.



PROCEDURE

1.CHECK DTC
a.

Check for CAN communication system DTCs.


OK:

CAN communication system DTCs are not output.



Result:
Result Proceed to
OK A
NG (for HV Model) B
NG (for Gasoline Model) C



A

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

B

C

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
a.

Replace the main body ECU (multiplex network body ECU).

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.RECHECK DTC
3.RECHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314

Result:
Result Proceed to
No DTCs are output. A
DTC C1AB8 is output ("Blind Spot Monitor Master"). B
DTC C1AB8 is output ("Blind Spot Monitor Slave"). C



A

END

B

REPLACE BLIND SPOT MONITOR SENSOR LH (MASTER)

C