When checking for DTCs, make sure that the blind spot monitor system is turned on.
Inspect the fuses for circuits related to this system before performing the following procedure.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Blind Spot Monitor Slave / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Buzzer Connection | Connection status of the buzzer | Valid or Invalid | Valid: Connection
Invalid: No connection |
- |
| Slave Side RCTA Function | Switches the RCTA function on and off | OFF or ON | OFF: RCTA function off
ON: RCTA function on |
- |
| Tester Display |
|---|
| Buzzer Connection |
| Slave Side RCTA Function |
| Result | Proceed to |
|---|---|
| "Valid" and "ON" is displayed for all items. | A |
| "Invalid" or "OFF" is displayed. | B |
A
B
According to the display on the GTS, check for DTCs.
According to the display on the GTS, check for DTCs.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to RCTA Buzzer (Blind Spot Monitor Buzzer)) |
| *b | Front view of wire harness connector
(to Blind Spot Monitor Sensor RH (Slave)) |
Disconnect the RCTA buzzer (blind spot monitor buzzer) connector.
Disconnect the blind spot monitor sensor RH (Slave) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| M45-1 (BZP) - Body ground | Ignition switch ON | 11 to 14 V |
| M45-2 (BZN) or M2-3 (BUZ) - Body ground | Ignition switch ON | Below 1 V |
| M45-2 (BZN) - M45-1 (BZP) | Ignition switch ON | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the M45 RCTA buzzer (blind spot monitor buzzer) connector.
Disconnect the M2 blind spot monitor sensor RH (Slave) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M45-2 (BZN) - M2-3 (BUZ) | Always | Below 1 Ω |
| M45-2 (BZN) or M2-3 (BUZ) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>REAR CROSSING TRAFFIC ALERT BUZZER>REMOVAL
NG