Signals are input into the position control ECU assembly (driver seat). The built-in ECU manages the signals received from the power seat switch and operates each motor. If the position control ECU assembly (driver seat) receives more than 2 motor operation signals for the same motor, the motor will be stopped. Manual operation resumes when the position control ECU assembly (driver seat) receives only 1 signal.
Inspect the fuses for circuits related to this system before performing the following procedure.
Check that each function of the power seat operates normally by using the front power seat switch (driver seat).
Click hereVehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM (w/ Memory)>OPERATION CHECK
| Result | Proceed to |
|---|---|
| All power seat functions do not operate | A |
| One or more power seat functions do not operate | B |
A
B
OK
NG
Disconnect the e23 and e25 position control ECU assembly (driver seat) connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| e23-3 (+B) - Body ground | Ignition switch off*1
Always*2 |
11 to 14 V |
| e25-15 (SYSB) - Body ground | Ignition switch off*1
Always*2 |
11 to 14 V |
| e25-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| e25-1 (IG) - Body ground | Ignition switch off | Below 1 V |
*1: for HV Model
*2: for Gasoline Model
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| e23-2 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| e25-12 (SGND) - e17-20 (E) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG